4ksq Throwout Bearing Replacement

[quk@isham-research.demon.co.uk (Phil Payne)]

In message <3533563A.75F2@sprintmail.com> Dave Fain writes:

> Since I don't have "supporting tool 2084" at my disposal, what
> is the best way to keep the crankshaft from rotating so that I
> can apply the 250 or so foot pounds necessary to break the
> bolt loose?

Stated torque is 332 lb ft.  Reckon on something closer to 400 for
breaking loose.

There's a procedure in the archives involving the use of a bolt in
the front of two round holes on the bell housing.  I've lost my copy
in a disk crash - perhaps some kind individual will forward it to us
both.

--
 Phil Payne
 Phone: 0385 302803   Fax: 01536 723021
 (The contents of this post will _NOT_ appear in the UK Newsletter.)