[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: Oil pressure icon blinking on '91 200Q



ARGGGHHHH!  I really was hoping it might be someplace outside the
instrument cluster.  Out comes the Bentley I guess.  Maybe I'll put a bulb
in the Check Engine light while I'm in there.  Any BTDT's on going after
the circuit board?

Frank



At 09:32 PM 7/15/98 -0700, you wrote:
>Frank:
>
>It could also be a failing circuit board in there.  I've heard of those
>going out, and the best Audi guy at Beverly Hills Porsche Audi confirmed
>that for me today.  So far, it's only the oil pressure icon for me.  I'll
>check the sending unit, and the contacts.  But, as you point out, it might
>also be bad contacts.  If so, I guess you have to get inside the instrument
>cluster.  
>
>- Jim
>
>
>
>
>
>
>
>At 10:08 PM 7/15/98 -0400, you wrote:
>>Must be a '91 200Q  epidemic!!!   Same thing happened to me Sat.  (same
>>drill - stop the car, check the oil level etc.)  same results.   Then again
>>yesterday except I'm smarter now - shut off then back on.  Whoops didn't
>>work,  auto-check still on.  Goes out  shortly thereafter.  Oil pressure
>>O.K.   I'm also having intermittent erroneous miles to empty readings.
>>Which contacts do I have to clean?
>>
>>
>>Thanks
>>Frank Stadmeyer
>>
>>'91 200Q		'89 100Q
>>'86 Jetta Gli		'85 Jetta
>>'73 BMW 2002  (hanger queen)
>>
>>
>>At 08:18 PM 7/14/98 -0700, James Desveaux wrote:
>>>Today I finally fixed the bothersome worn brake pad icon problem.  Went to
>>>my friendly german auto salvage yard in Watts and pulled the female-side
>>>brake sensor plug-in from an S4 and spliced it in, replacing the defective
>>>one.  About 2 hrs later, I drove over a pretty decent sized bump and
heard 3
>>>beeps.  This time the icon was red, and the oil pressure oil can started
>>>flashing.  THe oil pressure gauge was reading fine (between about 1.8-2.2
>>>bar at idle and up to 5 bar at speed).  THough I figured this is another
>>>typical Audi electrical gremlin, I pulled over, checked oil, etc.  After 3k
>>>miles since changing it, oil is exactly full (with none added) and there
are
>>>NO leaks.  I restarted the car, and the big OK lit up, and then the radio
>>>station.  A few seconds later, the beep returns with the red icon.  I keep
>>>driving down Bundy Drive (yes, THAT Bundy), and a short time later (hey,
the
>>>beep is gone), I notice that the radio station frequency is illuminated in
>>>the display.  No more beeps and icons.
>>>
>>>Question:  Anybody had this happen to them?  Is it a corroded connection at
>>>the sending unit, or some such thing?  The car has 91k on it now, but
>>>everything's pretty much spud on it.  I bought it at 88k and did the usual
>>>precautionary things, such as t/b, w/p, front main seal, etc.  Any advice
>>>would be appreciated.  
>>>
>>>- Jim
>>> 
>>
>>
>