Re: Replacing mirrors

["scott miller" <macatawa@hotmail.com>]

VW must have been ahead of Audi on this cost saver, my '86 and '87 
synchros had the same rusty heated mirror disease as my '90 200qw.  Does 
the heater just plug into the same socket?  Heater peeling is probably 
in the archives somewhere if I need it.  Is the blue tint part of the 
glass, or a coating?  I remember seeing blue mirrors in the plant, never 
paid much attention at the time.  If it's in the glass, I could just 
have a buddy etch off the silver and run the glass through the coater 
again.  I suppose I could live without the blue tint as well.

Scott

>    Note that Audi changed the external mirror construction around '89
>sometime. The old heated mirrors had the glass bonded to an aluminium
>backing plate. The newer heated mirrors have the mirror glued to a 
plastic
>backing plate. The newer mirrors are not well sealed, and the silvering
>corrodes and separates from the glass, giving a rusty look. The older
>mirrors are much more durable and, although they use a different mount
> rotating locking ring vs new plastic snap clips), the newer mirror 
drive
>will take the old mount and the old mirrors fit right in. I have 
replaced my
>drivers side glass which had "rusted" with one from my '86 5ktq ( I 
saved it
>from the wreck because it was convex - probably for a RHD car fitted by
>mistake - great view and no blind spot). The old mirror is in perfect
>condition - no sign of "rust".
>
>Fred Munro
>'91 200q  260k km
>-----Original Message-----
>From: scott miller <macatawa@hotmail.com>
>To: mdaniels@a4.org <mdaniels@a4.org>
>Cc: quattro@coimbra.ans.net <quattro@coimbra.ans.net>
>Date: Tuesday, October 13, 1998 6:30 PM
>Subject: Replacing mirrors
>
>
>>>10)The right side mirror is gone. The mirror assembly is there, just
>>the
>>>mirror itself is gone. What are the costs of something like that.
>>>
>>
>>I used to work at Donnelly, where most auto mirrors come from.  Just 
cut
>>a new one approximately, use an electric sander to round and trim the
>>edges.  Convex is a little more difficult, maybe find a bigger mirror 
in
>>the junkyard and trim it down.  Same would work for flat if you really
>>don't want to try glass cutting.  Some day I'll get around to 
replacing
>>my rusty mirrors, but I haven't looked at the heaters.
>>
>>BTW, team rusty mirror rose to great positions before putting a huge
>>skylight over the mirror inspection area.  That finally got the leader
>>fired!
>>
>>Scott
>>
>>
>>______________________________________________________
>>Get Your Private, Free Email at http://www.hotmail.com
>
>


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com