Re: intermittent power loss Update

[quk@isham-research.demon.co.uk (Phil Payne)]

In message <000001bdfe89$c38219e0$c80ac282@chris> Chris writes:

> The fault code on the computer is now 4444 which is meant to be no faults
> detected. But when you put the fuse in again you get 1111 which is control
> unit faulty ?? and then when you put the fuse in again you get nothing. Is
> this normal ? The next step we are going to do is to replace some of the
> sensors and see if that makes any difference. Also all the earth connections
> seem ok.
>
> Once again any advice appreciated

I've only seen 1111 once, and that was on an ECU that had been
incompetently fiddled with by SuperChips.

--
 Phil Payne
 Phone: 0385 302803   Fax: 01536 723021
 (The contents of this post will _NOT_ appear in the UK Newsletter.)