Yes, it is different . . .

[Mike Arman <armanmik@n-jcenter.com>]

>From: Todd Phenneger <phen9461@uidaho.edu>
>Subject: How To Remove 5k Rear SEat Back
>
>I cant seem to remove the rear seat back on my 5kt parts car.  This is a
>1985 5000 Turbo with Blue leather int.  I got the lower seat out but the
>back doesn't want to come  Does it lift out like the back on a 4kq or is
>ti different?
>	Thanks


Yes, it comes out differently. 

Straighten the tabs on the floor and lift the bottom of the seat back away
from them - You've probabaly already done this.

Now go into the trunk and pull back the fabric trunk liner just to the rear
of the seatback. You'll see some plastic mounts; each one has a tab on it
which must be depressed (push horizontally toward front of car) and then
lift out vertically. Coax them out with the end of a flat screwdriver - if
you have to push hard, the tab isn't released yet. I think you need to take
the headrests out first - remove the c-springs (4) and pull up.



BTW, I need the little black plastic trim bit shaped like a question mark,
fits at the top rear edge of the driver's door - fits between the door
panel and the window frame.

Send the trim bit to me at PO Box 785 Ormond Beach, FL 32175 - advise cost
via e-mail!


Best Regards,

Mike Arman