[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Looking to do a rear wheel bearing myself, etc.....



	You might consider pulling the entire rear strut and taking it to a machine
shop to have the old bearing pressed out and the new one pressed in.  It's
only a few more bolts than what you're going to have to pull to use the Schley
tool.  BTW, the last time I borrowed the tool set from my buddy in Nashville
the largest diameter puller was too small to pull the 5K wheel bearings (no
prob with the 4K though), so I would up pulling the entire front strut and
going to the machine shop anyway.

	Later.
	--ml