[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 92 Audi 100S, help with DLC jumper connector



You can look at www.12v.org under the maintenance section, under HowTo's
and it will show you which connectors to use--you can just get a scrap
of wire or something.
However I don't think that this will help you with your alarm
problem--the blink codes won't say anything about that.
Probably some sensor got misaligned and that's causing your alarm to go
bonkers.
--
Elliott

Karl Nitz-GKN001 wrote:
> 
>      I pulled the trouble codes from the check engine light on my 92
>      100S on Saturday.  I had no problem getting the codes, however I
>      have misplaced the jumper connector wire that normally connects
>      DLC1 and DLC2 in the relay box by the firewall under the hood.
>      Does anyone know what connects what on this connector?  I've been
>      unable to locate it in the Bentley manual.  Does anyone have a
>      spare to sell/send?  Ever since this connector has been missing,
>      the car alarm has been going off intermittently...is there a
>      logical connection between the missing connector and this??
> 
>      Regards,
>      Karl H. Nitz
> 
>      '92 100S, 78k miles, where's that f#@!ing connector?!?
>      '81 VW Rabbit Diesel, 200k miles, front suspension rebuild done
>      '97  Chrysler Sebring LXi, 33k miles, doing front brake pads today
>      '86 Kawi ZL600 and '85 Honda VF500F, almost warm enough to ride