Re: Hydraulic pump rebuild - Day 9

[rjandrew@post.cis.smu.edu (R Justin Andrews)]

Phil...
I used a very large pipe wrench on the cam gear and it held fine 
on my 4kq... Then again it is a non-interfernce motor....

HTH!
Rich Andrews
rjandrew@post.cis.smu.edu
> 
> Nah.  167,837.  Replacement pump (from scrapper) holding up fine - this
> is fortunately an off-line activity.
> 
> Took me 15 minutes to get the ball end of the damn tool out of the
> Allen screw.  Irritated me beyond belief.
> But has anyone found something that will
> just grip or block the wheel?
> 
> --
>  Phil Payne
>  Phone: 0385 302803   Fax: 01536 723021
>  (The contents of this post will _NOT_ appear in the UK Newsletter.)
>