[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Stebro Exhaust was mandrel bending etc..



In a message dated 6/15/99 2:15:03 PM Central Daylight Time, 
emaxon@megsinet.net writes:

<< I believe Stebro will custom make about anything out of T304 stainless
 steel-- the caviat is that they require a sample to copy.  As long as
 your downpipe is still intact (albeit full of holes) enough to establish
 the proper orientation of any flanges, they should be able to make one
 for you.  I got a ballpark quote of about $300 for a 5000cstq downpipe
 made from scratch out of T304, but never sent them the work (I had it
 TIG welded locally for $50 at a welding shop.)  If the pipe is indeed
 stainless steel, why don't you take it to a welding shop??  If not, give
 Stebro a try.  They're near Ottawa, Ontario-- northeast enough for
 you??? >>


I havn't seen a stebro exhaust made from 304 the two that I have seen were 
had from 409 stainless, and I paid a pretty penny for them as well, I should 
have gone with Scorpion.

Scott