Re: Brains trust question

[Richard J Lebens <rick-l@rocketmail.com>]

I believe this is the case.  Since the 90 deg. joint between the
torque wrench and the 2079 is rigid, you could replace the
wrench/adapter with a rectangular piece of steel of the same
dimensions.  Would it make any difference if you pulled one top edge
of the rectangle or pushed on the other?

This is what I figured out when I was torqueing some fittings using a
flare nut crows foot.  If I was wrong I'm sure I'll hear about it.  





---Phil Payne <quk@isham-research.demon.co.uk> wrote:
> If I hold the torque wrench as close to horizontal as possible with
> #2079 vertical, is the effect of #2079 nullified?
> 
 
_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com