Re: plastic fabrication

["Joseph Rae" <quattro@ptinet.net>]

I have been thinking of making fiberglass ducting for the urq/4000/cgt.....
but have not had time to make the mold..... though my urq has some cool
fiberglass and sheetmetal ducting for the radiator already but it is not
very pretty
Joe
----- Original Message -----
From: "c a l i b a n" <caliban@sharon.net>
To: "quattro" <quattro@audifans.com>
Cc: <coolian@thecia.net>
Sent: Thursday, September 09, 1999 11:48 AM
Subject: plastic fabrication


>
> i think you should make copies of the old abt dashboard
> extention for urq.  i had to pay $250 for mine - just a
> piece of plastic!  i am sure you'd have many buyers to
> make the cost low and worthwhile.
>
>
> --
>  rocky mullin
>  http://caliban.sf.ca.us/
>  two strokes are faster than four!
>  this message was composed using the vi editor.
>  '83 ur-q - yamaha rz350 - suzuki ts250 -  chaotic good
>