Re: No start problems

[Martin Pajak <urquattro@wave.home.com>]

Scott,

> Did you try connecting the low voltage LED test light across the two pin
> connector that plugs into the ignition coil transistor driver module, and
> crank over the engine? If this LED test light is blinking, the ignition
> coil should be producing a spark. Are you checking for spark at the coil,
> or at the spark plugs wires?

The LED was not flashing.

I found my problem though.

If you ever replace/splice in a new connector make sure that the wires do not
cross under the rubber boot.
I assumed the way they come out of the rubber boot the way they were in the
connector.
The connector was the one to the coil transistor driver module.

Thank you all for your responces.

I am happier than pig in crap that the engine is alive! : )

Cheers
--
Martin Pajak

http://www.geocities.com/MotorCity/5939

1983 Audi Ur-quattro (225,000 km)
1986 Audi 4000 S Quattro (415,000 km) with 5 bolt pattern