[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Cross-Drilled Rotors-The Answer



Well, I guess I've got the wrong rotors.  The correct ones are being
overnighted.  Sorry for the bandwidth.

Best Regards,
Gerry Snow

-----Original Message-----
From: Gerry Snow <gsnow@iea.com>
To: quattro@audifans.com <quattro@audifans.com>
Date: Tuesday, October 12, 1999 5:39 PM
Subject: Cross-Drilled Rotors


>Hi gang--Anyone have any experience fitting the Brembo cross-drilled front
>rotors from 2Bennett to an 84 4000q?  They are stock diameter (256 mm,
>10.079 in.), and other than the cross drilling and the very nice zinc
>plating, I understood them to be an essentially stock fit-up.  However, the
>disc surfaces are about 1/4" further inboard from the hub seating surface,
>so that the inner friction surface contacts the splash shield.  So, should
I
>remove the splash shield?  Or should there be some sort of spacer between
>the rotor and the hub (I wouldn't think so)?  Or is it possible that I have
>the wrong rotors?
>
>Best Regards,
>Gerry Snow