[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Sunroof



On Wed, 10 Nov 1999, Mark Hahn wrote:

>   To add on to some of the other sunroof problems I need to start working
> myself is that mine works strong except that the limit switches that should
> stop it from going from tilt to open at the closed position don't seem to be
> working.  Where are those limit switches located?  Thanks, MGH

Point of view: my 91 90q20v

1) Check the bentley for alignment procedures
2) In case of no #1:

The limit switches are a pair of microswitches that are attached to the
sunroof motor.  All this, on my car, is in the headliner area where the
sunroof switch is.  Open it up and you'll see the motor and the switches.
My switches were working fine but the problem was the wiring from the
microswitches to the relay was a little corroded/broken.  I don't plan on
using the sunroof for a while (winter, etc.) so I'll get to it next
season.

I found out by popping open the cover panel and wiggling the wires while
working the roof.  Some corrosion is visible there on my microswitch
contacts.  

Otherwise, Bentley has a procedure to align the microswitches and various
grooves in the motor gearing that will probably take you an hour or so to
do.  Best to check your (or your neighbor's) Bentley for the full Monty.

                               A crash reduces
                               your expensive computer
                               to a simple stone.
                               -- James Lopez