[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

inner sanctum- wiring gone awry?



Finished re attaching my passenger door window  when the through the glass
attachment bolt  appeared to shear.  Upon reassembly, the #26 fuse
blew, resulting in all guages and power mirrors inoperative. I replaced the
5amp fuse , voila!  all instrments working fine.Fine that is until I
adjusted my passenger side mirror- pop goes the fuse. Figurred I musta
disturbed  the
wiring from the switch to the mirror  when I was justling the inner door panel
trying to get  it aligned as part of the window alignment procedure.  II pulled
the panel off again, was not able to see any obvious trauma so I wiggled
the wires to see if i could  get lucky.  Well sort of- Now I can push the
passenger  mirror button and the control  works  only in one direction-
inward.  When I push the  drivers side  mirror button  the mirror works
properly in all direction, BUT  the RIGHT SIDE  mirror  turns  inward as
well.  Not blowing #26 fuse anymore, but apparently  shifted the 
errant wire(s) to create  an alternate symptom. Looks like Im going to
have to  get into this door yet again  with my Fluke  and  and see what s
touching what  under in the appropriate harness  or  connector.  Windows,
locks and guages are ok.   Am I missing something,
like  a misswired switch on the drivers door?  Worked ok before and haven't
messed with that door.    Anty BTDT folks  ?  Thanks,  Mike.