[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Reuse of head bolts ...



In a message dated 11/19/99 4:43:45 AM Eastern Standard Time, 
Steven.Buchholz@kla-tencor.com writes:

<< I probably should consider Raceware studs when I do the upgrade ... but my
 concern is a lack of knowledge of the proper way to install and tighten
 them.  They are not "stretch" bolts like the factory ones.  Does anyone
 _know_ the proper procedure for use of the Raceware studs in an Audi turbo
 head?  I assume that you have to check the torque on them some time after
 the engine has been run, how many miles/hours?  TIA again!
  >>

    We have ARP bolts for the I5 at Eurospec, and they come with their own 
torqueing specs, not too different from stock specs.  The order of tightening 
is the same, BTW...and I think you retourque them after the motor has been 
run for about 100 miles or so... Javad