[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Speaker wiring
In a message dated 11/22/99 9:22:10 AM Eastern Standard Time,
alexaudi@kki.net.pl writes:
<< Some time ago I replaced the head unit on my car and at the same time I
replaced the factory ever-breaking rear active crossover with a passive one
and also replaced the rear speakers (one of them was broken) with
aftermarket ones. Now I'm not sure if the front and rear speakers work in
the same phase. Is there a simple test I can do to determine if the
speakers are not out of phase? I don't have the wiring schematics for the
factory 10 speaker system so I had to figure it out using multimeter and am
not sure if I didn't make a mistake. Thanks in advance. BTW, the system
sounds quite nice, I'm just being anal ;-)
>>
That is not being anal, just doing the job right...out of phase speakers
do not sound as good a in-phase speakers because many of the frequences are
being cancelled, especially bass frequencies. To the triained ear, out of
phase speakers sound very distinct.
When sitting between the speaker you will have a hard time identifying the
source of the sound, and the sound stage will sound "hollow" in the middle,
it almost hurts your ears. By putting on some bass heavy music that extends
the speaker, you will see that one speaker may not move in the same direction
as the other. By barely touching the cones you will feel that both speakers
are not hitting your hand at the same time. This can be remedied by swapping
+/- on one of the speakers, and ensure that both rears are inphase with the
fronts...HTH
Javad