Re: Autocheck Temp Sensor

["Cobram ." <cobram@juno.com>]

 "Weeks, Chet" <Chet.Weeks@standardregister.com> writes:

>Listers-
>I have replaced the "multifunction sensor" at the front of the 
>cylinder head /block. The analog gauge now works (never gets very hot).
However, 
>the autocheck "high temp" warning continues to beep and flash indicating

>there is still a sensor defective somewhere. Any ideas of where next to 
>look???

Which indicator are you getting?  I'm getting the low coolant warning
(this feeds both from the multifunction switch and the coolant reservoir)
even through all sensors and wires are OK.  Check wires for continuity
with the wiring diagram.  One recommendation I've gotten is to open the
Autocheck 'puter and verify a cable in there that connects two printed
circuits together.  I haven't had a chance to do so yet, but it's
defintily an avenue to pursue, otherwise it look$ like a new Autocheck
Unit.....arggg

BCNU,
Cobram@Juno.Com
http://www.geocities.com/MotorCity/Flats/1469/

___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web: http://dl.www.juno.com/dynoget/tagj.