Re: Wiring for type 9004 to type 9007 bulb change

[Lawrence C Leung <l.leung@juno.com>]

Sorry for the redundant post, but I was looking for help from anyone
who'm has tried this. I have to replace the bulb sockets on my 2CTQ (DOT)
due to burn out from using 80/100W 9004's. I am about to try the type
9007 conversion to Xenons and I have read somewhere on this list that a
couple of wires needed to be swapped to do this. Since I am replacing the
sockets and intend to solder, I could use advance help on the wire swap
rather than doing the job twice. Do I switch yellow and brown (my guess)
or something else?

Larry - 2CTQ, A2 GTI (Solo2 w/Euro's the way things ought to be)