[200q20v] Correct distributor rotor?

[Glen Dustin Powell]

It also has the distributior cap to hold it in place.

-glen


-----Original Message-----
From: 200q20v-admin at audifans.com [mailto:200q20v-admin at audifans.com]On
Behalf Of C1J1Miller at aol.com
Sent: Thursday, August 17, 2000 9:37 PM
To: mod2000 at home.com; gpowell at ennovatenetworks.com;
william.kessell at worldnet.att.net
Cc: 200q20v at audifans.com
Subject: Re: [200q20v] Correct distributor rotor?


In a message dated 8/17/00 8:51:57 PM Eastern Daylight Time,
mod2000 at home.com
writes:

> Myself and a few other folks in the area are also "glueless in Seattle"
(bad
>  humor; couldn't resist).  I think Audi's concern is the possibility the
>  rotor could work its way off the shaft due to the angle of the
distributor.
>  When I recently replaced my rotor, the fit was so tight it seemed
>  unnecessary.  Anyone had any problems?
>
>  Mike O.

Well, it is subject to some severe heat cycling, vibration, and is mounted
horizontally for an average of about 100,000 miles...
chris

_______________________________________________
200q20v mailing list
200q20v at audifans.com
http://www.audifans.com/mailman/listinfo/200q20v