Rear Camber links in the 44 chassis

[auditude at cox.net]

So, where can the ends be sourced from?  The usual places, such as TPC, Blau, etc.?

Is there a cost savings, let's say if you have to replace both ends?

Thanks,

Ken

Shayne thequattroking at yahoo.com wrote:
>
> IBID, just BTDT.
>
> Shayne P.
>
> > From: Bernie Benz <b.m.benz at prodigy.net>
> >
> > Either or both rod ends can be removed from the link and relu;bed or
> > replaced, BTDT.
> >
> > Bernie
> >
> >> From: Kneale Brownson <knotnook at traverse.com>
> >>
> >> Aren't those supplied with the bushing material already installed
> >> on the link?
> >>
> >> At 02:13 PM 08/13/2002 -0400, Igor Kessel wrote:
> >>
> >>> Folks,
> >>> last I checked, they were not rebuildable. Perhaps it has changed
> >>> since? Is there a way to replace the bushing on the wheel hub side
> >>> of the link separately?
> >>>
> >>> Igor Kessel