Subject: IgorCamberPlate.pdf drawing is finished

[Bernie Benz]

It's the same plate mod as one would do to the 200 plate.  That 4mm
additional neg camber offset relative to stock, along with the negative
gain inherent with the Benz Strut brace, should be more than enough for an
optimum street alignment,with sufficient tolerence clearance.

Bernie

> From: Greg Johnson <gregsj2 at attbi.com>
> Date: Thu, 29 Aug 2002 20:17:23 -0700
> To: Igor Kessel <igor at s-cars.org>, Audi 200q20v list <200q20v at audifans.com>
> Subject: Subject: IgorCamberPlate.pdf drawing is finished
>
> Igor,
>
> So, I'm assuming this c-plate is for the S6.  Do you have one for the '91
> 200-20v and if so where is it parked.
>
> Greg J
> BIRA.ORG
>
>
>
> Message: 1
> Date: Wed, 28 Aug 2002 21:01:43 -0400
> From: Igor Kessel <igor at s-cars.org>
> To: Audi S-list <s-car-list at audifans.com>
> Cc: Audi Q-list <quattro at audifans.com>,
> Audi 200q20v list <200q20v at audifans.com>
> Subject: IgorCamberPlate.pdf drawing is finished
>
> Folks,
> due to the popular demand I have finally gotten around to redrawing the
> C4 chassis modification in the proper scale in Micrografx Designer and
> saved it in various graphic formats. Including the Adobe Acrobat format,
> which is very handy coz a) Acrobat reader is free and b) it preserves
> the scale of the drawing.
>
> Who wants it? Or perhaps Jimmy and/or Darin would like to post it on
> their respective sites? Gentlemen?
>
> --
> Igor Kessel
> two turbo quattros
>
>
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v