[200q20v] Drive shaft alignment?

[Bernie Benz]

Is that the wood with stripes?

> From: Phil Rose <pjrose at frontiernet.net>
> Date: Wed, 2 Jan 2002 18:08:44 -0500
> To: "Reid, Les C." <Les.Reid at Centrilift.com>
> Cc: 200q20V mailing list <200q20v at audifans.com>
> Subject: RE: [200q20v] Drive shaft alignment?
>
> At 2:26 PM -0600 1/2/02, Reid, Les C. wrote:
>> Thanks Bernie
>> Yes I will have to swing the exhaust out of the way (PIA).
>> The only  straight edge I have that is 5'long is a wood 2x4.
>> What kind of accuracy is needed? I really don't want to purchase a 5' level.
>> I suppose I could improve the straightness by running an edge through the
>> table saw.
>>
>
> With a decent tablesaw, you should be able to get adequate
> straightness from a 2x4 after a couple of light passes on both (of
> the narrow) sides (I'm assuming of course that the wood is reasonably
> dry and straight to begin with. ) Obviously would also be easy to
> make a notch for the u-joint.
>
> Zebrawood 2x4 recommended for best results. :-)
>
> Phil
> --
> *********************************
> *  Phil & Judy Rose           Rochester, NY  *
> *        mailto:pjrose at frontiernet.net       *
> *********************************
>
>
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v