output tests using vag-com

[Dan Simoes]

I got this reply from Ross-Tech.  Has anyone tested it on the 200?

Dan,

VAG-COM can perform output tests on vehicle that support them. See this
page:

http://www.ross-tech.com/vag-com/tour/out_test.html

Regards,
Andy

QSHIPQ at aol.com wrote:
>
> --
> [ Picked text/plain from multipart/alternative ]
> To  be more specific, the early motronic found in the 91 200 is not supported
> by aftermarket 1552 in terms of output test procedures.  You should get a
> "this function not supported" message, dan.  You can get stored fault codes,
> but you cannot do output tests with most of these tools.
>
> HTH
>
> Scott Justusson
> In a message dated 5/7/02 11:29:08 AM Central Daylight Time,
> rbwinchell at yahoo.com writes:
>
> Dan,
>
> You can use VAG-COM with the 2 prong adapter. You
> connect to the 2 connectors on the left (not the far
> right one).
>
> Block 0 is the only data block supported by the 3B
> engine. There are 10 values, which are listed in the
> Bentley.
>
> Rob Winchell
>
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v