ignition switch

[Peter Schulz]

Steve:

Trick is to find the right section in the Bentley manual that tells you where to drill about a 1/8 inch hole so that you can release a spring that holds the cylinder captive in the sleeve.


-peter

t 04:08 PM 4/30/2003 -0400, Steve Gronback wrote:
>What is the trick to removing the ignition switch cylinder from the cast
>iron sleave.  My electronic switch was cracked, which caused the failure of
>the ignition, but I want to change the key cylinder while I'm in here, if I
>can figure out how to remove it...
>
>Thanks,
>Steve
>
>
>_______________________________________________
>200q20v mailing list
>200q20v at audifans.com
>http://www.audifans.com/mailman/listinfo/200q20v

Peter Schulz
1990 CQ (awaiting S2 3b engine transplant)
1991 200 20v TQW indigo mica
1991 200 20v TQW titanium grey
Chelmsford, MA USA
peschulz at cisco.com