sealing the IC better?

[Bernie Benz]

In the past I have found that the stock lower worm gear type hose clamps
used to clamp the lower hose on either end are too long for a commpressed/
indented/ hose.  They bottom out without sufficient clamping force and the
hose will blow off.

Bernie

> From: Chewy4000 at aol.com
> Date: Mon, 05 May 2003 13:10:11 -0400
> To: 200q20v at audifans.com
> Subject: sealing the IC better?
>
> What was it that you guys were using to seal the lower IC hose or pipe?
> It just uses those rings that dont seem to be able to tighten better to stop
> those minor leaks.
> I just changed my timing belt, seal, and w/p, and would like to seal the turbo
> system better somehow especially the IC.
>
> Still wainting for the crank pin to come from the dealer for the flywhell to
> get the car running again.
>
> Chewy
> 200 20v 214k mi.
> Newark NJ
> _______________________________________________
> 200q20v mailing list
> 200q20v at audifans.com
> http://www.audifans.com/mailman/listinfo/200q20v