Help - The Bomb

[Richard Tanimura]

Phil,

Your questioning my procedure is justifiable but as I pointed out to you in
a private post, the other plugs changed using the same technique do not
leak. And you are certainly free to your opinions about why I do thing my
way. Frankly I wonder myself sometimes why I do things the way I do. But
that doesn't help me much.

I did find the suggestions made by Chuck and Bernie to be constructive and
helpful. Thanks nonetheless for your input.

R

-----Original Message-----
From: 200q20v-admin at audifans.com [mailto:200q20v-admin at audifans.com]On
Behalf Of Phil Rose
Sent: den 4 september 2003 17:51
To: Bernie Benz
Cc: 200q20V mailing list
Subject: Re: Help - The Bomb


At 8:13 AM -0700 9/4/03, Bernie Benz wrote:
>
>Phil, IMO there is absolutely no tech reason that any specific torque need
>be applied to these cyl. heads.  They screw into a flat metal to metal
>interface and can move no farther, this position leaves the correct squeeze
>on the O-ring.  A screw driver can easily achieve this metal to metal
>contact and no further torque is needed.  Thus, a drag link socket is not
>needed for installation nor for removal, as they can easily be removed with
>a chisel if not with a screw driver.

Bernie,
For one thing, using the drag-link socket certainly makes removal of
the caps less likley to create damage--especially if they had
previously been tightened to specs. Yes, I agree it's probably not
necessary to go all the way to the "specified" torque, except that
doing so provides a reliable means to know if adequate tightness was
actually achieved (again, without damaging the caps).  When someone
(e.g.,  Rich) has had do re-do the job several time over because of
leaks, there's reason to suspect all aspects of his
procedure--including the tightening torque used. Do it with a
drag-link and a torque wrench removes all doubts about _that_ aspect
of the job.

IMO, there's scant reason other than an emergency repair (or extreme
poverty/cheapness) to _not_ use the drag-link method and a torque
wrench.  I'll stick to doing (and recommending) my way.

Phil
--

Phil Rose
Rochester, NY
mailto:pjrose at frontiernet.net
_______________________________________________
200q20v mailing list
200q20v at audifans.com
http://www.audifans.com/mailman/listinfo/200q20v
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.515 / Virus Database: 313 - Release Date: 2003-09-01

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.515 / Virus Database: 313 - Release Date: 2003-09-01