Steerig column mount loose

[motogo1]

If you can't get it to stay tight, which I couldn't, but I didn't think of
trying  a clamp. But what I did do was to pull it tight by hand, then drill
a small hole across the taper and inserted a pin (nail). I then also put
some epoxy on the ends of the tapered joint.

Gary Martin
94 UrS4
91 200 TQA

----- Original Message ----- 
From: "Peter Schulz" <pcschulz at comcast.net>
To: "Chuck Pierce" <cpcycle at earthlink.net>; "200 list"
<200q20v at audifans.com>
Sent: Monday, November 28, 2005 9:06 AM
Subject: Re: Steerig column mount loose


> Chuck:
>
> Its a tapered, press fit....
> You may have to use a clamp to get it snug...
>
> BTDT
>
> -Peter
>
> At 11:21 PM 11/27/2005, Chuck Pierce wrote:
> >I pulled every thing apart to fix the bad ignition switch. As usual I
> >pulled everything to far apart.
> >I popped the steering column dove tail apart to get the switch/lock
> >assembly out.
> >I have everything back together, but the steering column is loose where
> >the mount dove tails together.
> >Has anyone put this back together? If so how did you get the dove tail
> >portion to get tight and stay tight?
> >
> >Thanks
> >Chuck Pierce
> >91 200tq Avant
> >
> >
> >_______________________________________________
> >200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v
>
> 1991 200 20v Q Avant Titan Grey
> 1991 200 20v Q Avant Indigo Mica
> 1991 90 20v Q Red
> 1990 CQ silver (awaiting S2 engine transplant)
>
> 1990 CQ red ( to part or not)
> Chelmsford Ma, USA
>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>