Blink Code 2111

[Bernie Benz]

Thanks, Kneale.

I¹ve not had to look into this so, I just speculated that if close was good,
a little closer might be better. I would usually just put the correct
thickness of scotch tape on the tip if the sensor and drive it home, as with
ABS wheel sensors.

Bernie

> From: Kneale Brownson <kneale at coslink.net>
> Date: Sat, 02 Dec 2006 22:59:45 -0500
> To: Bernie Benz <b.benz at charter.net>,<CLAG500 at aol.com>
> Cc: 200q20V mailing list <200q20v at audifans.com>
> Subject: Re: Blink Code 2111
> 
> Actually, Bernie, the Bentley calls for the ignition timing sensor to be
> 0.45-1.25 mm from the pin.  The RPM sensor is supposed to be 0.50-1.25 mm
> from the flywheel teeth.  Pages 13.34 & 13.35 describe how to place feeler
> gauges for these measurements.
> 
> 
> At 04:50 PM 12/2/2006 -0800, Bernie Benz wrote:
>> You can certainly check the sensor for open or short. Pull the sensor and
>> check/clean its face. Reinstall with it as close as possible into the FW
>> teeth, no adjustment here I think.