trans removale

RicebalLDR at aol.com RicebalLDR at aol.com
Wed Dec 27 18:14:38 EST 2006


Hi I have slowly been pulling apart my 200 avant 20v to replace a failed 
throw out bearing. I have the tranny moving to the rear but seem to be held up by 
the seat belt tension cables. I removed the side bracket but they seem to be 
cought on the top of the trans. Do I need to go forward with the trans and then 
try to release the cables or is there something else beside the vertical 
bracket on the side of the trans that needs to be removed? This project sure takes 
a long time with only an hour or two a week to work on it!!!!!!!!!  Thanks 
Richard Friedrich


More information about the 200q20v mailing list