trans removale

[Kneale Brownson]

You have to push the cables up next to the sheetmetal with the tranny
pretty much mated to the engine before you can get it past the cables.


At 06:14 PM 12/27/2006 -0500, RicebalLDR at aol.com wrote:
>Hi I have slowly been pulling apart my 200 avant 20v to replace a failed 
>throw out bearing. I have the tranny moving to the rear but seem to be held 
>up by 
>the seat belt tension cables. I removed the side bracket but they seem to be 
>cought on the top of the trans. Do I need to go forward with the trans and 
>then 
>try to release the cables or is there something else beside the vertical 
>bracket on the side of the trans that needs to be removed? This project sure 
>takes 
>a long time with only an hour or two a week to work on it!!!!!!!!!  Thanks 
>Richard Friedrich
>_______________________________________________
>200q20v mailing list	http://www.audifans.com/mailman/listinfo/200q20v