Ignition timing sensor removal

[Kneale Brownson]

Two bolts with (I think) 10mm heads hold these sensors and their bracket in
place.  Probably easiest to get to from underneath.    I've not removed
them from a 200, but on the V8, both fall out with their bracket.  No
prying/pulling required.


At 08:59 PM 7/25/2006 -0400, TooManyAudis at aol.com wrote:
>I want to remove the ignition timing sensor and possibly the ignition speed  
>sensor from my 200q to clean them and also check to see if the flywheel pins 
>are  in place (currently suffering a no-start condition, and the ignition 
>timing  sensor came up on the vag com).
> 
>any hints how to get this sucker out of its holder?  do I pull  out?  Pry?