oil pressure sender tips?

[Brandon Rogers]

PS - any tips on best way to remove/install this thing???  I have a
crows foot (I think that's the term- little open end wrench with socket
for a wrench extension)

Was thinking I'd try to get at from behind the rad - using the crows
foot and short ext on a wrench.  Keep in mind I'm working in a type 85
chassis - not that it should make much difference I think... 

Anyway - any tips appreciated.  Thx

Brandon

-----Original Message-----
From: Ed Kellock [mailto:ekellock at gmail.com] 
Sent: Monday, February 26, 2007 10:14 AM
To: brogers at terrix.com
Cc: 200q20v
Subject: Re: oil pressure sender p/n


Yup, that is the number shown in the FA for both MC and 3B.


On 2/26/07, Brandon Rogers <brogers at terrix.com> wrote:
> Hey Guys-
> My FA is out of commission - can somebody tell me the p/n for the oil 
> pressure dual sender?  My light glows sometimes (however I also have a

> gauge and the pressure is fine - but the light is annoying)  so I'm 
> thinking the sender is on the fritz.  The thing is such a PITA to get 
> at I want to make sure I have the proper replacement first. I have a 
> spare in my hand with p/n 035 919 561 A with pressure markings of 0-5 
> Bar and 1.8 +/- 0.2.  I assume the second range is for the dummy 
> light...
>
> thx
>
> Brandon
> '84 urquattro 20Vt
> '01.5 S4
>
>
> _______________________________________________
> 200q20v mailing list
http://www.audifans.com/mailman/listinfo/200q20v
>