Instrument Cluster/Alternator/Battery Charging Question

[db cornett]

I've done the diagnostic from the Bentley book on why my battery is not being charged (exciter test-120mA result, needs 150-185 mA).  It points to the "circuit board" in the instrument cluster as needing replacement.  Has anyone done the "circuit board" replacement successfully and which board is the correct one? 
   
  As background - new battery, clean terminals, new "Blue Wire of Death" connection to Ultranator, cleaned BWoD connector on passanger frame rail, cleaned and tightened chassis grounds.  Am I missing something?
   
  TIA, Doug
   
    

200q20v-request at audifans.com wrote: 
  Send 200q20v mailing list submissions to
200q20v at audifans.com

To subscribe or unsubscribe via the World Wide Web, visit
http://www.audifans.com/mailman/listinfo/200q20v
or, via email, send a message with subject or body 'help' to
200q20v-request at audifans.com

You can reach the person managing the list at
200q20v-owner at audifans.com

When replying, please edit your Subject line so it is more specific
than "Re: Contents of 200q20v digest..."


Today's Topics:

1. Instrument Cluster Resolder (Phil Rose)


----------------------------------------------------------------------

Message: 1
Date: Fri, 23 May 2008 15:31:17 -0400
From: Phil Rose 

Subject: Instrument Cluster Resolder
To: 200q20V mailing list <200q20v at audifans.com>
Message-ID: 
Content-Type: text/plain; charset="us-ascii" ; format="flowed"

Can't have too many clamps (old woodworker's adage) or too many DIY 
postings for '91 200q procedures. Today, one of our listers requested 
specific info pertaining to the solution I used to cure my "bouncing 
speedometer" problem. I sent him a couple of annotated JPEGS, which 
I have also added to my previously posted web listing for images on 
this topic. The new image files are called "photo_1_solder_fix.jpg" 
and "photo_2_reassembled_IC.jpg" and can be found here:

http://phil-rose.com/miscellaneous/IC_repair_photos



>Here are a couple of jpegs with comments describing what worked for 
>me. I had _two_ issues (1) the IC lighting effects and 2) also a 
>bouncing speedo), and I hoped that a single fix (the jumper) would 
>cure both. Not for me.
>
>I did the jumper wire and that cured the issue with dim 
>illumination, (bi)directional turn signal arrows and erroneous 
>hi-beam indicator, but the bouncing speedo needle persisted until I 
>noticed that there was a problem getting the ground fed to one of 
>the little pins coming through the circuit board near where the 
>ground-trace break occurs. This was an almost invisible break in the 
>solder joint at the base of the connector --the side connected to 
>the ground trace. I just touched this up with my low-wattage 
>soldering iron and the bouncing speed was cured. Two years and still 
>works fine.


Phil Rose

-- 

Phil Rose
Rochester, NY
mailto:pjrose at frontiernet.net


------------------------------

_______________________________________________
200q20v mailing list
200q20v at audifans.com
http://www.audifans.com/mailman/listinfo/200q20v


End of 200q20v Digest, Vol 55, Issue 15
***************************************