Hazet tool # 2593-22

[Phil Rose]

I don't believe anyone has yet mentioned using the 22mm "Offset 
Oxygen Sensor Wrench" (Performance Tool #W84008). It is a 3/8" drive 
and permits use with Torque wrench --AND also inserting an Allen 
wrench. I believe I bought mine at Pep Boys (I don't recall price but 
expect something like $10-15).

Phil

At 3:45 PM -0400 3/25/08, Rbade12 at aol.com wrote:
>I bought an inexpensive 22mm deep socket and ground 2 flats on the upper 
>part of it so it'd accept a 19mm open end wrench. I then held the allen screw 
>down the center of the socket while turning the 22mm with the open 
>end. Couldn't
>  measure torgue was the only drawback.   Bob  91 200q20v
>
>
>In a message dated 3/24/2008 6:15:46 P.M. Central Daylight Time, 
>adamgratz at gmail.com writes:
>
>Aloha  from the Jungle-
>
>The Jungle Racer is getting a front suspension  rebuild!
>
>Source for the special tool to tighten the front strut top  bolt while
>holding the allen screw strut shaft? (*Hazet tool # 2593-22*  )
>
>Looks like a deep (22mm) socket with a window cut in the side. No  tool shops
>on my Island  except a Sears (2 hour drive) and they had  less than a clue.
>
>Perhaps one of my fraternal 3B brothers would be  willing to loan one to a
>distant Island dwelling  cousin?
>
>Mahalo,
>
>Doc-
>808-960-3311
>_______________________________________________
>200q20v  mailing list     http://www.audifans.com/mailman/listinfo/200q20v
>
>
>
>
>
>**************Create a Home Theater Like the Pros. Watch the video on AOL
>Home.     
>(http://home.aol.com/diy/home-improvement-eric-stromer?video=15?ncid=aolhom00030000000001)
>_______________________________________________
>200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v


-- 

Phil Rose.....Rochester, NY USA
'06 A3q 3.2 V6 (5K, silver)
'91 200q	(156K, Lago blue)
Gone to Audi Valhalla:
'91 200q   (Tornado red)
'89 100 (Bamboo gold)