Hazet tool # 2593-22

[Rbade12 at aol.com]

I bought an inexpensive 22mm deep socket and ground 2 flats on the upper  
part of it so it'd accept a 19mm open end wrench. I then held the allen screw  
down the center of the socket while turning the 22mm with the open end. Couldn't 
 measure torgue was the only drawback.   Bob  91 200q20v
 
 
In a message dated 3/24/2008 6:15:46 P.M. Central Daylight Time,  
adamgratz at gmail.com writes:

Aloha  from the Jungle-

The Jungle Racer is getting a front suspension  rebuild!

Source for the special tool to tighten the front strut top  bolt while
holding the allen screw strut shaft? (*Hazet tool # 2593-22*  )

Looks like a deep (22mm) socket with a window cut in the side. No  tool shops
on my Island  except a Sears (2 hour drive) and they had  less than a clue.

Perhaps one of my fraternal 3B brothers would be  willing to loan one to a
distant Island dwelling  cousin?

Mahalo,

Doc-
808-960-3311
_______________________________________________
200q20v  mailing list     http://www.audifans.com/mailman/listinfo/200q20v





**************Create a Home Theater Like the Pros. Watch the video on AOL 
Home.      
(http://home.aol.com/diy/home-improvement-eric-stromer?video=15?ncid=aolhom00030000000001)