Re. Hub Shark Users

[Bernie Benz]

Pulling the hub from the bearing is trivial, almost a push out by  
hand job, and can be relubed and reassembled if all is in good  
condition. If well lubed at assembly the outer bearing housing is an  
easy press fit in the housing but your HS may not be up to it. Why  
screw with this sh*t? Do it right and complete or let it ride. A  
noisy bearing won’t hurt much.

Bernie


On Oct 28, 2008, at 11:01 AM, kneale at knitknacks.com wrote:

> Hub Shark pulled my 200q20v front hub for me, along with the  
> bearing inner
> parts, which I managed to extract from the hub, but I can't get it  
> to pull
> the outer.  Looks like 17 years of rust is participating in the  
> otherwise
> tight fit.
>
> Any other approaches?
>
> _______________________________________________
> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v