fuel line size?

[feelstranger]

Any suggestions on a good flare tool that is reasonably priced, and works 
well?


-----Original Message----- 
From: knitknacks at coslink.net
Sent: Tuesday, August 30, 2011 6:48 PM
To: feelstranger at hotmail.com ; knitknacks at coslink.net ; 200q20v at audifans.com
Subject: RE: Re: fuel line size?

Yup, I cut off the pipe near those fitting, extracted the threaded pieces 
and installed them on the
new piping.  You need the Euro flare tool to get the correct end to the 
pipe, however.



------- Original Message -------
>From    : feelstranger[mailto:feelstranger at hotmail.com]
Sent    : 8/30/2011 9:13:29 AM
To      : knitknacks at coslink.net; 200q20v at audifans.com
Cc      :
Subject : RE: Re: fuel line size?

Interesting, thanks
I haven't look closely, but can you re-use the fittings on the connections
behind the front wheel well?   I'm thinking - cut the end off, put it on the
new pipe before flaring?


-----Original Message----- 


I used the Cunifer 5/16-8mm stuff
http://store.fedhillusa.com/5168mmtubingandnuts.aspx.   ne 25-ft
length did the supply and return lines on 200s and V8s.



------- Original Message -------
>From    : feelstranger[ mailto:feelstranger at hotmail.com]
Sent    : 8/30/2011 6:41:46 AM
To      : 200q20v at audifans.com
Cc      :
Subject : RE: fuel line size?

What was the hard fuel line size again?  8 mm / 5/16?


Nat
_______________________________________________
200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v