fuel line size?

[Kneale Brownson]

My flaring sets are 1400 miles away until next week, but I think my ISO 
(needed for the Euro connections) kit is this one:  
http://www.thetoolwarehouse.net/p-17387-otc-4504.aspx

Amazon.com lists it a bit cheaper.

On 8/31/2011 7:23 AM, feelstranger wrote:
> Any suggestions on a good flare tool that is reasonably priced, and 
> works well?
>
>
> -----Original Message----- From: knitknacks at coslink.net
> Sent: Tuesday, August 30, 2011 6:48 PM
> To: feelstranger at hotmail.com ; knitknacks at coslink.net ; 
> 200q20v at audifans.com
> Subject: RE: Re: fuel line size?
>
> Yup, I cut off the pipe near those fitting, extracted the threaded 
> pieces and installed them on the
> new piping.  You need the Euro flare tool to get the correct end to 
> the pipe, however.
>
>
>
> ------- Original Message -------
>> From    : feelstranger[mailto:feelstranger at hotmail.com]
> Sent    : 8/30/2011 9:13:29 AM
> To      : knitknacks at coslink.net; 200q20v at audifans.com
> Cc      :
> Subject : RE: Re: fuel line size?
>
> Interesting, thanks
> I haven't look closely, but can you re-use the fittings on the 
> connections
> behind the front wheel well?   I'm thinking - cut the end off, put it 
> on the
> new pipe before flaring?
>
>
> -----Original Message-----
>
> I used the Cunifer 5/16-8mm stuff
> http://store.fedhillusa.com/5168mmtubingandnuts.aspx.   ne 25-ft
> length did the supply and return lines on 200s and V8s.
>
>
>
> ------- Original Message -------
>> From    : feelstranger[ mailto:feelstranger at hotmail.com]
> Sent    : 8/30/2011 6:41:46 AM
> To      : 200q20v at audifans.com
> Cc      :
> Subject : RE: fuel line size?
>
> What was the hard fuel line size again?  8 mm / 5/16?
>
>
> Nat
> _______________________________________________
> 200q20v mailing list    http://www.audifans.com/mailman/listinfo/200q20v
>
>
>
> _______________________________________________
> 200q20v mailing list     http://www.audifans.com/mailman/listinfo/200q20v
>