Removing rear window regulator assy. Help!

[Tony Hoffman]

You have to drill out one of the pulley rivets, then the slider can be
removed from the guide rail. Tap the center of that rivet, screw it in with
a short 6mm bolt. This is how I take them apart when rebuilding them, I
have to replace the cable in nearly every one.

Either way, glad to hear you got it taken care of.

Tony

On Sat, Aug 24, 2013 at 5:58 PM, Bernie Benz <b.benz at charter.net> wrote:

>  Well as suggested, I removed the whole inner window frame (PITA!) and
> the regulator. The tab crimped to the cable had broken out of the lifter
> pivot, a crimped over die casting which can not be removed from its guide
> rail. Crappy design! I was able to get the tab back into its place in the
> lifter and “wired” it in place with a piece of bare #14 cu wire, anchoring
> each end around either end of the stop adjusting screw, such that it didn’t
> interfere with the pivot pin. Lubed, works fine now. Will it last another
> 250K? Maybe, if I don’t hold static motor torque on the closed window.
> Regards, Bernie
>
>