Brake servo return hose

[Bernie Benz]

Jay,
“brake servo return hose“ You mean the 8” hose to the hyd reservoir with the 90deg bend fitting into the top of the brake servo? Pretty simple hose replacement, under no pressure. Don’t bother removing the fittiing, just put the new hose on it.

Tie rod end toe adjustments frozen up, ball joints still good. Years ago I torched mine to get them out, greased them and added a soft hose boot on each to keep the water out. Been fine since.

Bernie

On Dec 11, 2013, at 2:13 PM, Jay Kempf wrote:

> Anybody got a good clean brake servo return hose they could part with. Mine is pretty frozen up and I'd like to put one on that the nut is still spinning on the line. Also looking for a good set of front tie rods and tie rod ends. Mine are fine but are so frozen I can't really adjust so I'd like to swap them out to a clean pair.
> 
> Won my battle with the rear diff front bearing and seal. Got it all back together and filled it up with oil using an unorthodox method at best but it worked. Swapping out to my spare master and booster servo to get it back on the road finally.
> 
> Regards,
> 
> jfk
> 
> 802 272 5868
> jkempf at madriver.com
> 
> _______________________________________________
> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v