fuel pump question

[Mike Sylvester]

The fuel pump does not run until the engine cranks and the timing
reference sensor and the hall sensor in the distributor both line up.
If you remove the fuel pump relay and install a jumper, you will get
power to the pump.

Mike

> -------- Original Message --------
> Subject: fuel pump question
> From: Robert Bade <rbade12 at aol.com>
> Date: Sat, June 15, 2013 3:54 pm
> To: 200q20v at audifans.com
> 
> 
> I've got one question, with the key to run should I see voltage to the wire harness connector on top of the fuel pump access door. I get voltage to the 2 wires that work with the gauge sender, but, nothing to the 2 wires that connect to the fuel pump [green/yellow and brown]. Bentley has a means of checking using a remote on/off, removing the fuel pump relay...... but, it seems to me there should be power to the connector with the key to run. The fuel pump fuse is good. 
> 
> Thanks, Bob
> _______________________________________________
> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v