2048 crankshaft locking and positioning tool

[Jay Kempf]

Understood and I do but I am under the understanding that this is the 
crankshaft positioning tool for holding the thing in position during the 
entire TB job so I thought I should build one. The reason I want to have 
the dimensions of the original is so I can modify it to clip on 
somewhere else. Having the original allows me to work from that to get 
to somewhere else.

regards,

jfk

802 272 5868


On 4/25/2017 10:20 AM, Bernie Benz wrote:
> Not needed if you have a good impact wrench.
> Bernie
>
> On Apr 25, 2017, at 7:01 AM, Jay Kempf wrote:
>
>> I am looking at making a crankshaft locking tool (3B). I got close to the dimensions just based on some published stuff and have built a 3D model. I have a plasma cutter and welder and materials to make the thing but don't have the dimensions and clocking of the slot. Does anyone have one I could get them to take some measurements or to put it on a scanner to get the clocking of the slot? It would fit on a 8.5 x 11 all in one printer.
>>
>> -- 
>>
>>
>> regards,
>>
>> jfk
>>
>> 802 272 5868
>>
>>
>>
>> _______________________________________________
>> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v
>