2048 crankshaft locking and positioning tool

[Bernie Benz]

5th gear will do that.
B

On Apr 25, 2017, at 7:23 AM, Jay Kempf wrote:

> Understood and I do but I am under the understanding that this is the crankshaft positioning tool for holding the thing in position during the entire TB job so I thought I should build one. The reason I want to have the dimensions of the original is so I can modify it to clip on somewhere else. Having the original allows me to work from that to get to somewhere else.
> 
> regards,
> 
> jfk
> 
> 802 272 5868
> 
> 
> On 4/25/2017 10:20 AM, Bernie Benz wrote:
>> Not needed if you have a good impact wrench.
>> Bernie
>> 
>> On Apr 25, 2017, at 7:01 AM, Jay Kempf wrote:
>> 
>>> I am looking at making a crankshaft locking tool (3B). I got close to the dimensions just based on some published stuff and have built a 3D model. I have a plasma cutter and welder and materials to make the thing but don't have the dimensions and clocking of the slot. Does anyone have one I could get them to take some measurements or to put it on a scanner to get the clocking of the slot? It would fit on a 8.5 x 11 all in one printer.
>>> 
>>> -- 
>>> 
>>> 
>>> regards,
>>> 
>>> jfk
>>> 
>>> 802 272 5868
>>> 
>>> 
>>> 
>>> _______________________________________________
>>> 200q20v mailing list	 http://www.audifans.com/mailman/listinfo/200q20v
>> 
> 
>