[A4] front halfshaft removal

Brandon Rogers brogers at terrix.com
Wed Feb 22 13:24:28 EST 2006


thanks - much appreciated!
You've been very helpful several times.

Brandon
  ----- Original Message ----- 
  From: Pbadore at aol.com 
  To: brogers at terrix.com ; a4 at audifans.com 
  Sent: Wednesday, February 22, 2006 10:32 AM
  Subject: Re: [A4] front halfshaft removal


  On my 96 A4 2.8 l I removed the clamp bolt and nut and then pushed the two upper control arms out of the wheelbearing housing. If I remember correctly this allowed the wheelbearing housing to tilt enough to permit the axle shaft to be removed from the car. However, there is a good chance that the clamp bolt may be seized in the upper part of the wheelbearing housing. Audi has actually produced a special too to help remove the stuck clamp bolts-- I ordered one but the tool has been on back order for a while. If you do get the clamp bolt out I recommend that you use antiseize on the bolt and mounting hole on reassembly and buy a new self locking hex nut. Good luck.   


More information about the A4 mailing list