[A8] New to The List

[Cody Forbes]

Sure it's not both? I was pretty certain that it specifies to set BOTH upper 
arms at the proper angle to match vehicle rest height.

As an FYI to anybody out there that hasn't changed their upper arms yet: It's 
a sorta annoying job because Audi assembled them in such a way that the 
securing bolts can not be removed without removing the entire strut assembly 
from the car. If you re-install the bolts the other way around (bolt head 
closer to the spring) you can in the future remove the arms without pulling 
the strut assembly.

-Cody

--------------------------------------------------
From: "Britt Crowell" <britt at BrittCrowell.com>
Sent: Wednesday, April 27, 2011 9:08 AM
To: "Jason Wilkerson" <wilke_jb at yahoo.com>; <a8 at audifans.com>
Subject: Re: [A8] New to The List

> One of the upper control arms have to be set at the right position and
> tightened before reinstalling the strut/spring assembly. It's in the
> Bentley I think, and I believe it was in the instructions I got with my
> control arm kit too.
>
> Britt
>
> -----Original Message-----
> From: Jason Wilkerson [mailto:wilke_jb at yahoo.com]
> Sent: Wednesday, April 27, 2011 8:03 AM
> To: Britt Crowell; a8 at audifans.com
> Subject: Re: [A8] New to The List
>
> I did tighten them with the weight on the suspension, but I'm not sure
> what you are talking about when you mention the arm and strut?
>
>
> _______________________________________________
> A8 mailing list
> A8 at audifans.com
> http://www.audifans.com/mailman/listinfo/a8
>