[Biturbos4] First of my own wrenching of my '01 S4

[Single Malt]

That explanation was pretty good!  I fitted the clip onto the lower inlet
towards the outside of the car (there is a little protuberance that holds the
clip on the lower section) ... then I replaced the upper portion of that inlet
and it slips right onto that clip!  Thanks!!  That mystery is now solved.

-steve

--- dap128 <dap128 at hotmail.com> wrote:
> I know where that clip goes, but its kinda difficult to explain.  It goes on
> the air inlet next to the airbox... look at the bottom center of this one of
> your pictures:
> http://www.inners.com/s4airfilter/images/MVC-012F.JPG
> 
> Clips on the inside of that inlet to the airbox and holds the plastic pipe
> pictured here:
> http://www.inners.com/s4airfilter/images/MVC-018F.JPG
> in place.
> 
> Perhaps someone can explain it more clearly than that :)
> 
> -Dave Pramanik
> 
> ----- Original Message ----- 
> From: "Single Malt" <s_malt at yahoo.com>
<snipped for brevity>
> >
> > I came across an extra part under the filter.  Looks like some kind of
> > retaining clip.  I could not find a place that was obviously missing
> anything.
> > Anyone able to identify this? -third picture from the top
<snipped for brevity>


__________________________________
Do you Yahoo!?
Yahoo! Search - Find what you’re looking for faster
http://search.yahoo.com