[Es2] Before I go and auction my 200 flywheel, clutch, and pp...

[Dave K.]

Do any mods have to be made to the 7A flywheel to work on the 3B?

TIA,
Dave
----- Original Message ----- 
From: "Steve Eiche" <seiche at shadetreesoftware.com>
To: <desmo888 at comcast.net>
Sent: Thursday, January 15, 2004 2:33 PM
Subject: Re: [Es2] Before I go and auction my 200 flywheel, clutch, and
pp...


> The 200q flywheel cannot be used.  The CQ 01A transmission has a shorter
> input shaft and needs to have the pilot bearing in the flywheel.  The
> 200q flywheel is thinner, and has no provision for the pilot bearing as
> the bearing is in the crankshaft on 016 transmissioned cars.
>
> The timing pins on in the proper place on CQ flywheels.
>
> Steve
>
> desmo888 at comcast.net wrote:
>
> >I thought the 200 flywheel was used in the conversion. Are the timing
interupters the same on both flywheels?
> >
> >Dave K.
> >very early on in eS2 mod...
> >
> >
> >>None of this is better than the CQ's right?  I've been
> >>trying to re-read the threads on this, but can't make
> >>much sense of all the opinions....8-)
> >>
> >>No need for the 200's clutch, flywheel, or pp?
> >>
> >>__________________________________
> >>Do you Yahoo!?
> >>Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
> >>http://hotjobs.sweepstakes.yahoo.com/signingbonus
> >>_______________________________________________
> >>Es2 mailing list
> >>Es2 at audifans.com
> >>http://www.audifans.com/mailman/listinfo/es2
> >>
> >>
> >
> >_______________________________________________
> >Es2 mailing list
> >Es2 at audifans.com
> >http://www.audifans.com/mailman/listinfo/es2
> >
> >
> >
>