[Es2] Clutch/Pressure Plate

SigDesign at aol.com SigDesign at aol.com
Mon Mar 15 07:08:20 EST 2004


I have an aluminum flywheel from Fidanza (for the 7A), and plan on using the 
SPEC Stage 4 clutch (part # SA224). Flywheel was $240.00 (Ebay) and the clutch 
is about $450.00 from SPEC.

Mark S.
'90 RSCoupe (project)



In a message dated 3/14/2004 9:58:16 PM Central Standard Time, 
avangerb at zoo.uvm.edu writes:
    Howdy folks!  A productive Sat, 6 hours of work and the 90 coughed a
mostly intact 7A motor.  Had a chance to pop the flywheel off and start
comparing clutch/pp setups.  Unfortunately none of the pressure plates I
grabbed will work with the stock 5 speed...

R/S4 clutch plate has the proper spline count, fits
RS4 pressure plate does not have the proper dowel holes and is the wrong
height
RS2 pressure plate has the proper dowel holes, but it would appear the 6
speed flywheel is way different than the 5 speed 7A flywheel, no possible
fitment

    So back to square one, a stock 7A pressure plate will not handle the
power, the stock trans probably won't either, but we shall see.  So curious,
does Sachs make a sport/power pressure plate for the 90q20v or CQ?  OR does
anyone have a better solution for 7A flywheel and stock 5 speed?

    OR what about an S2 3B pressure plate, looking at Schulz's pictures
gives me that feeling like I should have ordered a early S2 pressure plate
and not an S2 ABY / RS2 pressure plate, dang!

    Something just popped into my head, friend has a SPEC clutch setup for
his urS4 lying around, I'll take a peak at that one tomorrow...

Thanks!

Alexander van Gerbig

Europrice

Waitsfield, VT 05673


More information about the Es2 mailing list