Lower Panel Removal 91 100

Henry A Harper III hah at srv.net
Sat Dec 2 16:02:05 EST 2000


On Saturday, December 02, 2000 2:05 PM, Kneale Brownson 
[SMTP:knotnook at traverse.com] wrote:
> Don't know about 100's, but my '91 200q20v panel below the steering wheel
> is removed by taking out one screw in the switch housing around the
> steering column, one screw on the edge of the panel near the brake pedal,
> one near the bottom corner of the dash at the door opening that also
> releases the bottom of the end panel on the dash, which kind of slides down
> and out, and, finally, two screws visible after the end panel on the dash
> is removed.  The screws behind the end cap on the dash are allen-type
> socket head screws that take a 4 or 6 mm hex bit.  I can't recall whether
> the switch housing screw is that type or a Phillips.  The two lower screws
> are Phillips, I think.
>

All 5 of these fasteners on my 200q20v are 4mm hex...along with the door pull 
fasterners, glovebox fasterners, etc.

Henry




More information about the quattro mailing list